Use the following command to install Lynx through Homebrew:.Install Homebrew on the Mac if you have not done so already. You can install Lynx with Homebrew or with MacPorts. With that in mind, let’s review how to install and run a working version of Lynx in Mac OS X. Thankfully it’s very easy to install a working version with the help of MacPorts or with Homebrew. Users can report known probelms to Unidata's GEMPAK Support desk ( and are encouraged to post updates and questions to the GEMBUD mailing list ( as well.Anyway, after updating to a new version of Mac OS X I discovered my previous installation of lynx was not functioning. Although basic run-time testing on OS X-compiled GEMPAK has been successful, it's possible there may be bugs in the OS X build which are not seen on other platforms. No doubt some individuals with different CPUs/OS versions may discover some problems not mentioned or covered here. If all went well, run make installĪnd you should be good-to-go. Once done, verify there are no fatal errors in the make.out file (there should be two non-critical Error 2 messages but no Error 1 messages. In a separate window, you can watch the compilation process by typing tail -f make.out To build the package, which may take a long time, depending on the speed of your computer. Then cd into the $NAWIPS directory (this is the parent directory of the GEMPAK/N-AWIPS directory tree).īe sure you are cd'd into the top level GEMPAK6.10 directory at this time. Compile GEMPAK From SourceĮxtract the GEMPAK tarball archive obtained from the GEMPAK Downloads page and modify Gemenviron or Gemenviron.profile depending on your shell so that the environmental variable $NAWIPS is set to the correct directory path. In the top level of OpenMotif 2.3.3: configure -prefix=/opt/local make all Setenv CFLAGS -I/opt/local/include setenv LDFLAGS -L/opt/local/lib You may wish to build the previous version, 2.3.3. Note: the latest (2.3.4) version of OpenMotif has been problematic building from source, although the binaries work. This appears no longer to be the case although for reference, the instructions for a source-code build of OpenMotif appear below. In the past (see below), OpenMotif was either not present on MacPorts, or it was necessary to build from source due to problems with the binary. Installing xorg-libXmu will also install xorg-libXt, xorg-libsm and xorg-libice. Installing xorg-libXp will also install xorg-printproto. Installing Xft2 will also install xorg-renderproto and libXrender. Installing fontconfig will also install freetype. Sudo port install Xft2 xorg-libXp xorg-libXmu xpm Install packages sudo port install xorg-libXtst fontconfig jpeg libpng splint xbitmaps In order to compile GEMPAK you must install gcc. This will take a long time, perhaps even a couple hours if you are on a slower/low-RAM system. Look for the latest non-beta build (e.g., 4.9). provides a DMG download for the 10.7, 10.8 and 10.9.Īdd /opt/local/bin to the beginning of $PATH Finally, update all installed packages: sudo port -v selfupdate 2. You can install Command Line Tools stand alone with the following command: sudo xcode-select -installĪnd a popup window will appear asking you about install tools. Installing command line tools changes slightly than previous versions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |